Introduction
Profile Unity RTA is basically the tank version of the famous Profile RDA released back in 2018 by Mr JustRight1 and Wotofo. It’s a joint project between Wotofo, Mr JustRight1 and TVC, The Vapor Chronicles. It uses NexMesh wire as heating material and same spring ceramic block tactic as Profile RDA to ensure not too tight or too loose wicking. Today we’ll do a Profile Unity RTA review.
Features provided by manufacturer Wotofo:
- 25mm diameter
- 3.5ml juice capacity with 5ml extension tube included
- Top fill method
- Compatible with mesh wire
- Adjustable mid airflow system
- German peek insulator
Package includes:
- 1x Profile Unity RTA
- 1x 5ml glass tube
- 1x 5ml chimney extension adapter
- 1x User manual
- 2x 0.13ohm nexmesh coil
- 1x 6mm agleted cotton
- 1x Bending tool
- 1x Screw driver
- Spare parts
First impression
The Profile Unity RTA is a 25mm diameter RTA that originally holds 3.5ml liquid, and with an extension tube and bigger glass tube the juice capacity bumps up to 5ml. Filling the Profile Unity RTA is pretty simple, just half turn the top cap and then you can fill liquid through the filling slot. It doesn’t come with extra drip tip though, Wotofo always provides tons of accessories with their products but this one we don’t have extra 810 drip tip and 510 drip tip adapter. Build quality is top notch as usual. The airflow adjustment ring locates at the middle of the Profile Unity RTA and it’s very easy to adjust.
Build & Wick
The Profile Unity RTA has got a mesh build deck which is almost the same as the Profile RDA. It’s not the easiest deck to build yet it’s not difficult to build either. If you use the Profile RDA before, building and wicking this Profile Unity RTA would be a piece of cake. We can release the post clamps by using flat head screw driver or Philip head screw driver. Bend the NexMesh wire with the bending tool and pop them into the building slots. Then tighten the screws. Everything is simple and natural. Make sure you check the resistance first and put on the chimney section to check if there’s any short before moving forward to dry burn and wick it up. Wicking is the most important part when it comes to RTAs, if not properly wicked, the RTA will either give you dry hit or leakage. Follow the Wotofo user manual and cut the leads of the cotton at an angle you should be good to go.
Performance
I find it vaping the best at around 70W-75W, when setting it up to 90W it didn’t vape as well as lower wattage and I almost got dry hit. There isn’t too much difference between flavor from 3ml version and extended 5ml version. I personally like to use the 5ml glass as it lasts a bit longer. Otherwise we have to refill the tank again and again.
Pros
- Nice looking tank
- Smooth airflow
- Easy to build
- Convenient half-turn top cap to fill liquid
- Great flavor
- 5ml glass and extension piece included
- Top notch build quality
Cons
- No 510 drip tip adapter
- Wicking slot is not quite big, need to cut the cotton carefully so that the liquid can flow nicely
